Shipping today to NSW, ACT, VIC, TAS, SA, QLD, WA, NT

Victron Energy MultiPlus Inverter/Charger 24/3000/70-50 - 230VAC/50Hz Sinewave

Length: 21.8
Width: 25.8
Height: 36.2
Brand:  Victron Energy
Short Discription: 

PMP243021011

Only 1 left

AU$2,815.00
OR

Victron Energy MultiPlus Inverter/Charger 24/3000/70-50 - 230VAC/50Hz Sinewave

You may also be interested in the following product(s)

Victron Energy MultiPlus Inverter/Charger 24/5000/120-100 - 230VAC/50Hz Sinewave

Additional Information

Brand Victron Energy
Weight 18.0000

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

• Multi-functional, with intelligent power management The MultiPlus is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology, and a high-speed AC transfer switch in a single compact enclosure. Next to these primary functions, the MultiPlus has several advanced features, as outlined below.

• Two AC Outputs The main output has no-break functionality. The MultiPlus takes over the supply to the connected loads in the event of a grid failure or when shore/generator power is disconnected. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption. The second output is live only when AC is available on the input of the MultiPlus. Loads that should not discharge the battery, like a water heater for example, can be connected to this output (second output available on models rated at 3kVA and more).

• Virtually unlimited power thanks to parallel operation Up to six Multi's can operate in parallel to achieve higher power output. Six 24/3000/70 units, for example, provide 15kW / 18kVA output power with 420 Amps of charging capacity.

• Three phase capability In addition to parallel connection, three units can be configured for three-phase output. But that’s not all: with three strings of six parallel units a 45kW / 54kVA three phase inverter and 1260A charger can be built.

• Split phase options Two units can be stacked to provide 120-0-120V, and additional units can be paralleled up to a total of 6 units per phase, to supply up to 30kW / 36kVA of split phase power. Alternatively, a split phase AC source can be obtained by connecting our autotransformer (see data sheet on www.victronenergy.com) to a ‘European’ inverter programmed to supply 240V / 60Hz.

• PowerControl - Dealing with limited generator, shore side or grid power The MultiPlus is a very powerful battery charger. It will therefore draw a lot of current from the generator or shore side supply (nearly 20A per 3kVA MultiPlus at 120VAC). With the Multi Control Panel a maximum generator or shore current can be set. The MultiPlus will then take account of other AC loads and use whatever is extra for charging, thus preventing the generator or shore supply from being overloaded.

• PowerAssist - Boosting the capacity of shore or generator power This feature takes the principle of PowerControl to a further dimension. It allows the MultiPlus to supplement the capacity of the alternative source. Where peak power is so often required only for a limited period, the MultiPlus will make sure that insufficient shore or generator power is immediately compensated for by power from the battery. When the load reduces, the spare power is used to recharge the battery.

• Four stage adaptive charger and dual bank battery charging The main output provides a powerful charge to the battery system by means of advanced ‘adaptive charge’ software. The software fine-tunes the three stage automatic process to suit the condition of the battery, and adds a fourth stage for long periods of float charging. The adaptive charge process is described in more detail on the Phoenix Charger datasheet and on our website, under Technical Information. In addition to this, the MultiPlus will charge a second battery using an independent trickle charge output intended for a main engine or generator starter battery.

• System configuring has never been easier After installation, the MultiPlus is ready to go. If settings have to be changed, this can be done in a matter of minutes with a DIP switch setting procedure. Even parallel and 3-phase operation can be programmed with DIP switches: no computer needed! Alternatively, VE.Net can be used instead of the DIP switches. And sophisticated software (VE.Bus Quick Configure and VE.Bus System Configurator) is available to configure several new, advanced, features.

 

DOWNLOAD

__download pdf

DATASHEET


Write Your Own Review

You're reviewing: Victron Energy MultiPlus Inverter/Charger 24/3000/70-50 - 230VAC/50Hz Sinewave

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Quality
Price
Value
Latest Blog

How does an Apricus Solar Hot Water system work?

Before you invest in a solar hot water system it’s good to understand how they work, and how your purchase will be advantageous to your household or business. 

Read more...

New Stiebel Eltron Products

NEW single phase electric instantaneous water heater released 

Read more...

VoltLogic gets grid connection approval

Renewable energy technology developer Renewable Energy Solutions Australia (RESA) has received approval for its VoltLogic power management device to connect to the grid in sections of NSW where power export limitations for larger solar systems have been introduced.

Read more...

Solar Power - towards 2050

Solar Power is stronger than ever. Solar panels in 2014 are producing 4.9% more power than they were three years ago. 

Read more...